The Humble 'Virtual Chimney' Fences That Could Reduce The Impact Of Airport PollutionMain Category: Water - Air Quality / Agriculture
Article Date: 05 Feb 2013 - 0:00 PST
The Humble 'Virtual Chimney' Fences That Could Reduce The Impact Of Airport Pollution
|Patient / Public:|
1 (1 votes)
Simple 'blast' fences called baffles could deliver improvements in air quality for people living near airports, new research has found.
Placed behind a runway, the baffles could serve as a 'virtual chimney', funnelling emissions from aircraft engines upwards where they can disperse more effectively, thereby reducing the environmental impact on people living nearby.
Prototype baffles have been tested by a team of researchers from Manchester Metropolitan University, Cranfield University, the University of Southampton and the University of Cambridge, with funding from the Engineering and Physical Sciences Research Council (EPSRC).
After preliminary wind tunnel testing of various baffle shapes carried out by Cranfield University, an array of three rows of baffles was tested using laser scanning (Lidar, which is the optical equivalent of Radar) and chemical sensor techniques at Cranfield Airport in Bedfordshire. This demonstrated that the aircraft exhaust plume could be made to leave the ground within the airport's boundary fence, using prototype baffles of less than a man's height and constructed out of low-cost agricultural windbreak netting on lightweight frames.
Dr Mike Bennett, who led the project, says: "Airfield surfaces are typically covered with grass, over which the wind can blow freely. An array of baffles makes the surface rough in an aerodynamic sense. This sucks the momentum out of the exhaust jet, allowing its natural buoyancy to come into play. By suitably angling the baffles, we can also give the exhaust an upwards push, encouraging it to rise away from the ground.
"The baffles we tested were tilted at angles between 40° and 60° in order to optimise this vertical flow - and to ensure the baffles didn't blow over! Although the exhaust will still disperse to the ground eventually, it will do so at a lower concentration. We might hope to see a reduction in surface concentrations of around 50 per cent at the perimeter fence behind the place where aircraft are taking off."
Long-term ground-level nitrogen dioxide (NO2) concentrations around many major airports in Europe already exceed the legal limit enforced by the EU.
The aim of the trial was essentially to test the baffles' aerodynamics. As the prototype installation was temporary, it was constructed very differently from how a permanent installation might be made. Each baffle must be sufficiently robust to withstand the 80-90 knot blast from a jet engine, but flimsy enough to collapse harmlessly if an aircraft were to hit it. In the trial, this was achieved by restricting the prototype baffle widths to about two metres but it would be feasible to make them much narrower in a permanent installation. For full-scale use an area of baffles in the order of a thousand square metres would need to be erected behind a runway.
The tests also showed that the baffles dampened engine noise downstream by a modest amount and were helpful in reducing jet blast on the airport perimeter.
"There's no reason why baffles couldn't start to be installed at airports within two or three years," Dr Bennett says. "From the point of view of local air quality, they represent a quick, cheap supplement to developing low-NOx jet engines."
The project was carried out under the auspices of the EPSRC-funded Airport Energy Technologies Network (AETN), which was established in 2008 to undertake cutting-edge research in the field of aviation.
Visit our water - air quality / agriculture section for the latest news on this subject.
The aircraft used in the field tests at Cranfield Airport was the Natural Environmental Research Council’s (NERC) Facility for Airborne Atmospheric Measurements, a four-engined BAe146. The aircraft took off 12 times in all and on each occasion burned its engines for 5 -15 seconds at the end of the runway prior to take-off.
Lidar is the optical equivalent of radar. A pulsed ultra-violet laser beam was scanned through the exhaust plume in order to monitor the plume’s dispersion.
The initial projects associated with the AETN were the outputs of an EPSRC Sandpit event in November 2009. Sandpits are intensive discussion forums where free thinking is encouraged in order to delve deep into specific issues and identify innovative solutions.
The Engineering and Physical Sciences Research Council (EPSRC) is the UK’s main agency for funding research in engineering and physical sciences. EPSRC invests around £800 million a year in research and postgraduate training, to help the nation handle the next generation of technological change. The areas covered range from information technology to structural engineering, and mathematics to materials science. This research forms the basis for future economic development in the UK and improvements for everyone’s health, lifestyle and culture. EPSRC works alongside other Research Councils with responsibility for other areas of research. The Research Councils work collectively on issues of common concern via Research Councils UK.
Engineering and Physical Sciences Research Council
22 May. 2013. <http://www.medicalnewstoday.com/releases/255761.php>
Please note: If no author information is provided, the source is cited instead.
Contact Our News Editors
For any corrections of factual information, or to contact the editors please use our feedback form.
Please send any medical news or health news press releases to:
Note: Any medical information published on this website is not intended as a substitute for informed medical advice and you should not take any action before consulting with a health care professional. For more information, please read our terms and conditions.